I appreciate all comments and thank you in advance for your help. I have found that it is possible to use ImageDataGenerator.flowfromdirectory () but I use LAB images and I would like to feed my model with a numpy array of the L component (256, 256, 1). As far as I am concern, BatchISP uses serial com while I intend to use USB connection. I have 5000 images (256x256x3) and would like not to load all data in my program (for memory reason). Does it mean that I need to use BatchISP to program or I can use FLIP2.2.4. In the Keil uVision 2 program under AT89C5131 data base, I found this statement:-įLASH='batchisp' (-device $D -hardware RS232 -port COM1 -baudrate 19200 -operation MEMORY FLASH LOADBUFFER %H PROGRAM) VCC Pin 40 provides supply voltage to the chip. Load Program For At89C51 Trial Timer Circuit Read More 8051 Projects, Electronics Projects, Microcontroller Projects, power source 1 Opinion Industrial Timer Circuit SumSeptemEngineeering Projects Humans are born of routines, they wish more and more comfortable. Is it true that I can program the HEX into the microcontroller directly through USB or I need special programmer? In an 8031-based system in which an external ROM holds the program code, this pin is connected to the OE pin of the ROM. I intend to use USB connection to program into the microcontroller. I would like to confirm whether it is true that I can use the Keil uVision 2 to generate the HEX file and then use the FLIP 2.2.4 to program the HEX file into the microcontroller or I can use the Keil uVision 2 to program into the microcontroller? From the Atmel website, I found out that i could use Keil uVision and Flip 2.2.4.

How to load program for at89c5131